Taylor guitar came about in 1974 when Bob Taylor began creating them. Semi-electric and acoustic is what Taylor specializes in. Dave Matthews, Jewel, and Bryan Adams and are some of artists who use this Taylor guitars. There is no difference in replacing strings on a Taylor guitar than any other guitar, and it is important to do so to have great sound.
1.You must first loosen up the strings on the guitar. Metal adjusting heads come standard on all Taylor guitars. Rotate each to left to ease the strings till you can eliminate them through pulling each string from tuning gear mechanism hole. Next, go to base of your guitar, at bridge. If you have and electric guitar, then you can remove the string just by pulling it out. For the acoustics, eliminate the plastic string holder from bridge and then lift out the string of the hole of the string. Roll the old strings up to eliminate them from poking your fingers or ripping through the waste bags.
2.Arrange the new strings. Medium and light gauge work best. Every string comes wrapped in it’s own wrapper for easy way to tell what it is. Every wrapper has a name of a string written on it. You need to lay out the string in an order of them being changed.
3.Take out the first string from its wrapper and place it in the hole of the string under your guitar. Sketch your string beside fret board till it is absolutely taut, and position it in accurate tuning head. The skinniest string goes in first tuning key located on the right, then others go up right-side then down the left. Then twist your string two to three turns around the tuning head base to make certain it will stay safe, after which give the tuning key two to three turns to tighten your string and secure it in place.
4.Put every string on your guitar by following similar method described above. Once every one of the strings are on your taylor guitar, start out with the skinniest string and rotate every tuning head about three to four turns to tighten the strings. Alternate when doing this, starting out with thinnest string, and then the thickest, the second thinnest, and then the following thickest. By using this technique will allow to remain even pressure on your taylor guitar neck. Make sure that every string is in the correct slot on your guitar nut, installed across the top of your guitar neck.
5.Take every string between your index and thumb finger and then pull it up, far away from the neck of your guitar. Pull your string till you feel some tension on it. Do this four to five times. If you do this it extends your strings before you break them in, adjusting them, and helping to keep your taylor guitar in tune after you tune it up.
6.Tune each string with the reference note or if possible a digital tuner. Alternate when you tune. Start out with skinniest string and take it steadily up to the pitch, and then go to thickest string and bring it steadily up to the pitch. Keep on tuning by means of this alternating method till you have finally tuned the new strings.
Article Source: http://www.articlesnatch.com
About the Author:
I have been playing and teaching How To Play Guitar for over twenty years. Many newbies ask me “What is the best guitar for beginners?” That is why I wrote a Baby Taylor Review. This guitar is most excellent for rookies in my opinion.